Below are answers to frequently asked questions about PT-VW360 Series projectors.
Does this projector have a lens-shift function?
No, it doesn’t.
If the no-input signal state continues for a while, the projector will enter standby mode. Why?
If no input signal is detected for a certain period, the projector enters standby if Power Management is set to [SHUT DOWN]. If [PROJECTOR SETUP] -> [ECO MANAGEMENT] -> [POWER MANAGEMENT] is set to [OFF] via the main menu, the projector won’t enter standby when no input signal is detected for a certain period.
The <ON (G) / STANDBY (R)> power indicator is blinking red. Is something wrong?
This is normal. The <ON (G) / STANDBY (R)> power indicator blinks red to indicate that the projector is in standby with standby mode set to [NORMAL]. The indicator blinks in a 2.75 to 0.25-second on/off cycle when Standby Mode is set to [NORMAL], and 2.75 to 0.25-second on/off to 0.75 to 0.25-second on/off cycle when Standby Mode is set to [NETWORK]. When the projector’s standby mode is set to [ECO], and the projector enters standby, the power indicator lights red.
The <ON (G) / STANDBY (R)> power indicator is blinking green. Is something wrong?
No, there is nothing wrong. The power indicator is blinking green for one of the following reasons:
(1) The projector is in the process of powering up the lamp. In this case, the indicator blinks in a 0.5 to 0.5-second on/off cycle. The image will be projected after a brief interval.
(2) The projector is on, but the lamp is off. The projector is in a Ready condition with Power Management function activated. In this case, the indicator blinks in a 2.0 to 2.0-second on/off cycle.
What is the maximum number of displayable colors?
This projector supports a maximum 16,770,000 colors.
Do you sell a carry bag for storing and carrying the projector?
We don’t currently sell an optional carry bag for this product. Please consider a suitable third-party alternative.
The projector is equipped with LAN terminal. Does it support DIGITAL LINK?
No, it does not.
What is the difference between this projector and VW350 Series?
The main difference is that PT-VW360 Series offers an optional wireless LAN function. If you use the optional ET-WML100 wireless module, you can connect to wireless LAN. In addition, the Picture-in-Picture (P-in-P) function has been deleted.
Does the projector have a shutter function?
No, it doesn't.
The <WARNING> indicator is lit red. Is something wrong?
A red <WARNING> light indicates that the inside of the projector unit is getting too hot. Please check if:
- The air intake/exhaust ports are obstructed (clear if necessary)
- The air filter is clogged (clean or replace if necessary)
- The unit is being used within the specified operating range of 0–40 °C (32–104 °F). When used at altitudes between 1,400 m (4,593 ft) and 2,700 m (8,858 ft) above sea level, the operating temperature range becomes 0–30 °C (32–86 °F).
If the <WARNING> indicator is still lit after confirming the above, turn the MAIN POWER switch to OFF and ask your dealer or point of purchase for assistance.
Is the projector equipped with a REMOTE terminal for contact control?
No, it isn't.
Is it possible to disable image display without turning off the power?
Yes, you can temporarily disable image display and audio by pressing the AV MUTE button on the remote control or the projector’s control panel. Audio will be unmuted and image displayed when the AV MUTE button is pressed again.
Does this product have Direct Power Off that allows the power to be turned off immediately after use?
Yes, it does.
Is the audio from the VARIABLE AUDIO OUT terminal output for each input?
Yes, audio from each input can be output via the VARIABLE AUDIO OUT terminal. Note that when a cable is connected to the VARIABLE AUDIO OUT terminal, no audio is output from the built-in speaker.
