Installation1-Chip DLP™ Projectors
PT-FRQ60 SeriesPT-FRQ60 / PT-FRQ50
 PT-FRQ60 |
 PT-FRQ50 |
|
|---|---|---|
| Projector type | 1-Chip DLP™ projector | |
| DLP™ chip | ||
| Panel size | 16.5 mm (0.65 in) diagonal (16:9 aspect ratio) | |
| Display method | DLP™ chip x 1, DLP™ projection system | |
| Number of pixels1 | 1920 x 1080 pixels (If a signal other than 120 Hz/240 Hz is input, it cannot be displayed at this resolution.) |
|
| Light source | Laser diodes | |
| Light output2
?
ISO/IEC 21118: Brightness measured complied with ISO/IEC 21118: 2020 international standards. Measure average illuminance level (lux) of 9 points which are divided on the projected area, and multiply by projected area (m2). Value is the average of all products when shipped. ANSI lm: Brightness measured complied with American National Standards Institute standards. Measure average illuminance level (lux) of 9 points which are divided on the projected area, and multiply by projected area (m2). Value is the average of all products when shipped. Result of Brightness measured complied with ISO/IEC 21118 and ANSI will be same. Center lm: Measured Illumination level at the center of screen (lux) multiplied by projected area (m2). Value is the average of all products when shipped. When comparing projectors, it's essential to ensure that the brightness ratings are measured using the same standard to get an accurate comparison. |
6,000 lm3 / 6,000 lm (ANSI)4 / 6,200 lm (Center)5 | 5,200 lm3 / 5,200 lm (ANSI)4 / 5,400 lm (Center)5 |
| Time until light output declines to 50 %6 | 20,000 hours (NORMAL/QUIET)/24,000 hours (ECO) | |
| Resolution | 4K (3840 x 2160 pixels) (With Quad Pixel Drive) | |
| Contrast ratio3 | 20,000:1 (Full On/Full Off) (When [PICTURE MODE] is set to [DYNAMIC] and [DYNAMIC CONTRAST] is set to [1]. HDMI signal input) |
|
| Screen size (diagonal) | 1.02–7.62 m (40–300 in), 16:9 aspect ratio | |
| Center-to-corner zone ratio3 |
90 % | |
| Lens | 2.0x manual zoom (throw ratio: 1.46–2.93:1), manual focus, F 2.0–3.4, f 21.5–43.0 mm | |
| Lens shift (From the origin point of the lens mounter) |
||
| Vertical | +71 %, -48 % (manual) | |
| Horizontal | +34 %, -27 % (manual) | |
| Keystone correction range | Vertical: ±40 °, Horizontal: ±20 ° | |
| Installation | Ceiling/floor, front/rear, free 360-degree installation | |
| Terminals | ||
| HDMI IN 1/2 | HDMI 19-pin x 2 (Compatible with HDCP 2.3, Deep Color, 4K/60p signal input7), CEC supported | |
| COMPUTER IN | D-sub HD 15-pin (female) x 1 (RGB/YPBPR/YCBCR) | |
| MONITOR OUT | D-sub HD 15-pin (female) x 1 (RGB/YPBPR/YCBCR) | |
| AUDIO IN/OUT | M3 stereo mini-jack x 2 | |
| SERIAL IN | D-sub 9-pin (female) x 1 for external control (RS-232C compliant) | |
| DIGITAL LINK/LAN | RJ-45 x 1 for network and DIGITAL LINK connection (video/network/serial control) (HDBaseT™ compliant), 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net, HDCP 2.3, Deep Color, 4K/60p signal Input8, Extron XTP®) | |
| LAN | RJ-45 x 1 for network connection, 10Base-T, 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net) | |
| USB | USB connector (Type A) x 1 for optional AJ-WM50 Series Wireless Module, for USB memory, and for power supply (DC 5 V, maximum 2 A) |
|
| Supported Internet Protocol Versions | IPv4, IPv69 | |
| Power supply | AC 100–240 V, 50/60 Hz, AC 110 V, 60 Hz (Taiwan) |
|
| Maximum power consumption | 505 W (5.5–2.4 A) (525 VA) (0.5 W with Standby Mode set to ECO, 15 W with Standby Mode set to NORMAL) | 480 W (5.0–2.2 A) (500 VA) (0.5 W with Standby Mode set to ECO, 15 W with Standby Mode set to NORMAL) |
| On-mode power consumption (Operating mode) |
|
|
| Cabinet materials | Molded plastic | |
| Operation noise3 | 36 dB (NORMAL/ECO) / 31 dB (QUIET) | 35 dB (NORMAL/ECO) / 28 dB (QUIET) |
| Dimensions (W x H x D)10 |
498 x 168 x 492 mm (19 5/8˝ x 6 5/8˝ x 19 3/8˝) | |
| Weight11 | Approx. 16.4 kg (36.2 lbs) | Approx. 16.1 kg (35.5 lbs) |
| Operating environment | Operating temperature: 0–45 °C (32–113 °F12), operating humidity: 10–80 % (no condensation) | |
| Applicable software | Logo Transfer Software, Multi Monitoring & Control Software, Early Warning Software, Projector Network Setup Software | |
| Control Function via LAN |
Crestron Connected™ V2, Crestron XiO Cloud™13, Art-Net DMX, AMX® DD, and PJLink™ (Class 2) | |
| Terminals PT-FRQ60 Series |  |
|
1 If a signal other than 120 Hz/240 Hz is input, it cannot be displayed at this resolution.
2 When [PICTURE MODE] is set to [DYNAMIC], [DAYLIGHT VIEW] is set to [OFF], [DYNAMIC CONTRAST] is set to [OFF], [LIGHT OUTPUT] is set to [100%], and [AUTO POWER SAVE] is set to [OFF].
3 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118: 2020 international standards. Value is the average of all products when shipped.
4 Measurement, measuring conditions, and method of notation all comply with American National Standards Institute standards. Value is the average of all products when shipped.
5 Average light-output value of all shipped products measured at the center of the screen.
6 Around this time, light output will have decreased to approximately 50 % of its original level ([PICTURE MODE]: [DYNAMIC], [DYNAMIC CONTRAST] set to [2], temperature 30 °C [86 °F], elevation 700 m [2,297 ft] with 0.15 mg/m3 of particulate matter). Estimated time until light output declines to 50 % varies depending on environment.
7 4K/60p signals are converted to the projector's resolution upon projection.
8 4K/60p signals are converted to projector’s resolution. Supports YPBPR 4:2:0 format only.
9 Main firmware version must be 3.00 or higher. Optional AJ-WM50 Series Wireless Module is not compatible with IPv6.
10 With legs fully retracted.
11 Average value. May differ depending on the actual unit.
12 When using the projector at an altitude lower than 2,700 m (8,858 ft) above sea level, and the operating environment temperature becomes 35 °C (95 °F) or higher, the light output may be reduced to protect the projector. When optional AJ-WM50 Series Wireless Module is attached, operating temperature range becomes 0–40 °C (32–104 °F).
13 Main firmware version must be 3.00 or higher.
